#System console with dsp builder steps how to
#System console with dsp builder steps software

The APU inside PS is configured to run in SMP Linux mode. The Evaluation Tool also makes use of multiple processing units available inside the PS like Gigabit Ethernet, I2C, and SD Interface. The AXI DMA is configured in Scatter- Gather (SG) mode for high performance. The Stream Pipes comprises of various AXI4 Stream Infrastructure IPs. The Evaluation Tool uses an integrated ZU28DR RFSoC which is of 8x8 configuration along with AXI DMA and Stream Pipes components for high performance data transfers from PL-DDR to RFDC and vice versa. The system level block diagram of the Evaluation Tool design is shown in the below figure.

#System console with dsp builder steps software

Xilinx PetaLinux flow is used to create and integrate the software components, including Linux kernel and drivers. Xilinx Vivado IPI flow is used to create the hardware design which is partitioned between the processing system (PS), RFDC IP, and programmable logic (PL). The Evaluation Tool allows user to configure the operation of the RF-ADCs & RF-DACs including the associated clocking system, to perform signal generation and capture using RFDACs & RFADCs and to perform RF metrics computation on signal capture for input test signals. The Evaluation Tool consists of a ZCU111 evaluation board and a custom graphical user interface (UI) installed on a Windows host machine. The Evaluation Tool serves as a platform for Xilinx customers to evaluate the ZynqВ® UltraScale+в„ў RFSoC features and helps them to accelerate the product design cycle. The design demonstrates the capabilities and performance of the RFdc (RF-ADC and RF-DAC) available in ZynqВ® UltraScale+в„ў RFSoC devices. This document provides the steps to build and run the RFSoC RF Data Converter Evaluation Tool. The UG provides the list of device features, software architecture and hardware architecture.Zynq UltraScale+ ZCU111 RFSoC RF Data Converter TRD user guide, UG1287.

#System console with dsp builder steps how to

How to build all the Evaluation Tool components based on the provided source files via detailed step-by-step tutorials.ДЄdditional material not covered in this tutorial.

How to setup the ZCU111 evaluation board and run the Evaluation Tool.

This tutorial contains information about:

A detailed information about the three designs can be found from the following pages. In the subsequent versions the design has been split into three designs based on the functionality. As mentioned above,in the 2018.2 version of the design, all the features were the part of a single monolithic design.